Chase Paymentech Debit Card Setup
| This article is part of the
Payment Processing Software Library
|Connect to it...|
|Set it up...|
|Learn to use it...|
|More Info ...|
→ Looking for better rates? Get a Free Credit Card Processing Cost Comparison!
Please see Processor Support Contact List
Firewall And Connection Information
IMPORTANT: If using a firewall, please open port 443 for both incoming and outgoing traffic
This information is set in c:\911\data\ccv_link.ini
Pin Pad Setup
CreditLine Credit Card Software interfaces to this device through a serial port. The serial port is specified in 911\data\CLCAPI.INI file like so:<br\> → Note: every pin pad will autopopulate a section with terminal client name like so [PINPAD.TERMCLIENTNAME]. Remove the three synch lines KeySyncDate, TPK and TAC to reinitialize the pin pad. Individual TerminalID settings for the pin pad must be placed under each relevant section (create if not present).
Initialization will occur on the second attempt (the first attempt will result in error)
→ Important: if using back office to record and edit stored cards make sure set a [PINPAD.xxxx] where xxxx is the BO server name with Enabled=0 to avoid the clcUI code bringing up the pin pad unless one is attached to the server.
Pin Pad Default for all terminals [PINPAD] ;TerminalID is taken from the Settlement Setup of the Debit Card by default TerminalID= Enabled=1 ; 1=PinPad is enabled PortDef=COM1:9600 ; COM Port and Baud Rate for attached Pin Pads ;Pin Pad type ;1 = Verifone (default) ;2 = IDT ;3 = Ingenico 3070 Type=1 UsePinPadSwipe=0; 0 = Do not use Pin Pad for card swipes. Default = 0; ;Terminal specific override (optional) ;TERMCLIENTNAME is the name given to the client by the calling API [PINPAD.TERMCLIENTNAME] ;TerminalID is taken from the Settlement Setup of the Debit Card by default ;Note that multiple pin pads must have individual Terminal IDs assigned to them by the processor TerminalID=003 Enabled=1 PortDef=COM2:115200 Type=3 UsePinpadSwipe=1 QuickSetPinEntryData=0 ForceCurrentKey=0 ;The following section confirms the correct correct and synch - autopopulated ;REMOVE THIS SECTION TO REINITIALIZE KeySyncDate=20120426 TPK=CB60CA9DB4961B03 TAK=2EA255B90B9062D8 KeyIndex=1
Also see Pin Pad for individiual pin pad connection settings.
- Card Ranges are not used in debit cards and are ignored
- Class Default means that this setup is the default for all debit card connections (normally, you will only have one)
- Select the fields as shown below
→ Make sure to check Apply to Auths!