Ingenico i3070

From Payment Processing Software Library
Jump to: navigation, search
This article is part of the
Payment Processing Software Library

Categories

Get it...

Credit Card Software
Download

Install it...

Installation
Upgrade & Migration

Connect to it...

Point Of Sale Integration

Set it up...

Quick Start Guide
Setup
Processor Setup

Licensing

Learn to use it...

Manual & User Guide
Knowledge Base
Frequently Asked Questions
Compliance Guide
Merchant Account Rates
User Interface Guides

Fix it...

Errors & Troubleshooting
Knowledge Base
Corrupted Install Repair

Get Help...

Contact
Processor Support Contacts

More Info ...

Glossary
Articles

See also...

911 Software
Help

CreditLine Payment Processing Software Processor Setup - Ingenico. This site can also be reached at http://docs.911software.com

Looking for better rates?   Get a Free Credit Card Processing Cost Comparison!

Ingenicoi3070.gif


CreditLine Interface

CreditLine Credit Card Software interfaces to this device through a serial port. The serial port is specified in 911\data\CLCAPI.INI file like so:<br\> → Note: every pin pad will autopopulate a section with terminal client name like so [PINPAD.TERMCLIENTNAME]. Remove the three synch lines KeySyncDate, TPK and TAC to reinitialize the pin pad. Individual TerminalID settings for the pin pad must be placed under each relevant section (create if not present).

Initialization will occur on the second attempt (the first attempt will result in error)
→ Important: if using back office to record and edit stored cards make sure set a [PINPAD.xxxx] where xxxx is the BO server name with Enabled=0 to avoid the clcUI code bringing up the pin pad unless one is attached to the server.

Pin Pad Default for all terminals 
[PINPAD]
;TerminalID is taken from the Settlement Setup of the Debit Card by default
TerminalID=
Enabled=1 ; 1=PinPad is enabled
PortDef=COM1:9600 ; COM Port and Baud Rate for attached Pin Pads
;Pin Pad type 
;1 = Verifone (default)
;2 = IDT
;3 = Ingenico 3070
Type=1
UsePinPadSwipe=0; 0 = Do not use Pin Pad for card swipes. Default = 0;

;Terminal specific override (optional)
;TERMCLIENTNAME is the name given to the client by the calling API
[PINPAD.TERMCLIENTNAME]
;TerminalID is taken from the Settlement Setup of the Debit Card by default
;Note that multiple pin pads must have individual Terminal IDs assigned to them by the processor
TerminalID=003
Enabled=1
PortDef=COM2:115200
Type=3
UsePinpadSwipe=1
QuickSetPinEntryData=0
ForceCurrentKey=0
;The following section confirms the correct correct and synch - autopopulated
;REMOVE THIS SECTION TO REINITIALIZE 
KeySyncDate=20120426
TPK=CB60CA9DB4961B03
TAK=2EA255B90B9062D8
KeyIndex=1

Documents


Also see

Pin Pad